How to Install led Flood Light

how to install led flood light

Installation method

There are usually 4 installation methods for floodlights, namely wall mounted, sit type, ceiling mounted and high pole-mounted.

Wall mounted is the most common, both low-power and high-power floodlights can use this installation method. Use a percussion drill to drill holes on the wall, and fix the spotlight on the wall with expansion bolts. Then connect the wires and adjust the angle of the spotlight.
Sit type is usually used for landscape and garden lighting. Use expansion bolts to fix on hard ground, or use ground nails to insert into soft ground, use waterproof joints to connect wires and protect wires.
Ceiling mounted is usually used for indoor and outdoor installation of buildings, and the installation method is the same as wall mounted.
High pole-mounted is usually used for large-area outdoor lighting such as stadiums and squares, and generally uses multiple high-power floodlights from 300W to 1000W.

Before installing the LED floodlight, in order to ensure the quality of use after installation, it is recommended to check the floodlight carefully before installation, check whether the appearance of the LED floodlight is damaged, whether the accessories are complete, and whether the after-sales service is in place. To double check.
After the appearance is not damaged and the accessories are complete, the LED lights need to be installed on site and then installed. First, organize the installers according to the installation drawings attached to the factory, first connect a few floodlights, try to install the drawings, and then Try to install again, if possible, arrange for one person to install each lamp one by one, and then install according to the installation diagram attached by the factory.
Remind the installation workers to pay attention to the importance of fixed lines and wiring, especially the waterproof of outdoor wiring is very important. It is best to check again when fixing the connection.
After the LED flood light is fixed and wired, it is best to use a multimeter to check whether there is any abnormality such as short circuit of the wiring before turning on the light.
After all the LED lights have been tested, try to brighten them for a period of time, and check again the next day and the third day. After doing this, all the lights are good, and there will be no problems later.

Alibaba Platform: https://gzyaoliang.en.alibaba.com/